Steamdromeda

The web version for some reason doesn't recognize modifier keys or tab, so Z/X/C/Enter are available as alternatives to Shift/Control/Alt/Tab. 

Within the editor: 
- Click and drag from the box on the left to get new parts
- Click and drag to move parts
- Control/X click and drag to move all connected parts
- Alt/C click and drag to copy a part
- Shift/Z click and drag to connect two adjacent parts
- Middle click to switch a part between Copper and Steel
- While holding a part, use Q/E to rotate it 
- Press tab/enter to exit

Outside the editor: 
- WASD to control fans
- Hold H to turn on all heaters

Fluids: 
- White = Steam
- Blue = Water
- Orange = Fuel

Parts: 
- Fans take steam as input from the sides and create thrust when WASD is pressed. 
- The boiler takes water in from the wide end and outputs steam to the narrow end if it's above 100 °C
- The heater takes steam or fuel from the thin ends and produces heat when H is held. (consumes a lot of steam if provided)
- The piston creates a joint between itself and a configurable rod . They're free floating right now and might get motors in the future.
- Pipes transfer fluids to any connected tiles. 
- Tanks store a large amount of fluid
- Pipe connectors transfer fluids with other pipe connectors they touch, use them to get your starter fluids.

Misc:
- The ground and air are at -50 °C. 
- Fans stop working at -25 °C
- Anything below 0 °C is tinted blue, anything above 100 °C is tintied red.
- On downloadable versions, press F11 to toggle fullscreen. 
- Repository : https://github.com/Mycellf/steamdromeda